Whole-home duct cleaning
Dryer vent cleaning
Camera inspection
Sanitizing & deodorizingWhole-system duct and dryer vent check with before-and-after photos - you see exactly what came out of your vents
That "$99 whole-house special" is a bait ad - the real number appears once they are in your hallway, or the "clean" is a shop-vac at the register. We photograph the inside of your ducts before and after instead.
Trusted Duct Repair & Sealing for Williamsburg Homeowners
If your energy bills keep climbing while certain rooms never feel quite right, the problem is often not the furnace or the AC. It’s the ductwork between them and you. Leaky joints, torn flex runs, and disconnected trunk lines bleed conditioned air into crawlspaces and wall cavities before it ever reaches a register. We handle duct repair & sealing as a dedicated service, not an add-on to a vacuum job, because sealing the system is what makes every other step count. Our technicians have up to 13 years of experience and use the same Rotobrush and Nikro equipment professionals rely on. Call (833) 508-9915 to book an inspection.

What Our Duct Repair & Sealing Service Includes
Duct repair is diagnostic work before it’s mechanical work. We trace the system, find where it’s losing air or pulling in contaminants, and fix the cause rather than tape over a symptom. Here’s what each part of the service covers.
Duct Sealing
Duct sealing closes the gaps at joints, seams, and connections where air escapes under pressure. You need it when rooms closest to the equipment run hot or cold while distant rooms stay flat, or when you can feel air moving around a register frame. We seal the accessible runs and connections, then confirm airflow at the registers before we leave.

Flex Duct Repair
Flex duct is the corrugated, silver-jacketed run you’ll see in attics, basements, and mechanical chases. It tears, sags, or gets kinked during other trades’ work, and a crushed run can cut airflow to a room by a wide margin. We repair damaged sections, re-support sagging runs so they stay straight, and reconnect boots that have pulled loose.

Metal Duct Repair
Sheet-metal trunk lines and branch ducts develop separated seams, popped fasteners, and crushed sections over time. You need metal duct repair when a run is noisy, whistling, or visibly dented, since a collapsed section restricts the whole branch. We resecure seams and joints and straighten damaged sections where the metal allows.

Duct Insulation
Insulation on ductwork in unconditioned spaces keeps conditioned air from losing its temperature before it reaches a room. Missing, wet, or deteriorated insulation shows up as condensation, rusty duct jackets, or a room that never matches the thermostat. We replace failed insulation on accessible runs so the air arrives at the temperature you paid to produce.
Mastic Sealant
Mastic is the brushable sealant HVAC contractors use on seams and joints, and it holds up far better than duct tape in a hot attic or a cold crawlspace. You need it wherever joints are loose, dusty, or already failing with old tape. We clean the surface and apply mastic so the seal bonds to the metal and stays put.
Air Leak Repair
Air leak repair is the targeted hunt for leaks that aren’t obvious, often at the plenum, the register boots, or where ductwork passes through a wall. You need it when the system runs long, the house is dusty, or a room is starved for air with no visible damage. We locate the leaks and close them so the system moves the air it was designed to move.
Styles & brands we work with
- Whole-home duct cleaning
- Dryer vent cleaning
- Camera inspection
- Sanitizing & deodorizing
Brands We Service for Duct Repair & Sealing
We service Rotobrush rotary-brush systems and know where they wear out. The brush head, the flexible shaft, and the vacuum hose all take a beating over years of use, and a worn shaft or frayed hose reduces cleaning effectiveness before it fails outright. When a Rotobrush system needs attention during a job, we know what to check.
We also work with Nikro negative-air and vacuum equipment, and with Honeywell and Aprilaire filtration and air-quality products as part of the sealing and sanitizing scope. Nikro gear is built for containing dust and debris during service, and we use it that way so a repair doesn’t spread contamination through the house. Whether you have Rotobrush, Nikro, Honeywell, Aprilaire, or any other make, we can help.
Signs You Need Duct Repair & Sealing Right Now
- Rooms that never match the thermostat. If the far bedroom runs several degrees off from the rest of the house, a leak or a crushed run is often the cause. Sealing and repairing the run restores balanced airflow.
- Rising energy bills with no change in use. A leaking system runs longer to hit the setpoint because it’s losing air it already paid to condition. Sealing the leaks is usually the fix.
- Visible dust around registers or streaks on ceilings. Dust pulling in at a loose joint or boot leaves a trail. That’s a sign the system is drawing from an unconditioned space, not just that the ducts are dirty.
- Whistling or rattling when the system runs. Noise at a register or a trunk line usually means a restricted or separated section. It’s worth checking before a small tear becomes a disconnected run.
- Condensation or rust on duct jackets. Moisture on insulated ductwork points to failed insulation or a leak pulling humid air in. Left alone, it can lead to microbial growth inside the system.
Our Duct Repair & Sealing Process – Step by Step
- 1
Inspection and airflow check. We start by tracing the system and checking airflow at the registers and the equipment. This tells us where the pressure is going and which runs are suspect before we open anything up.
- 2
Leak detection. We check joints, seams, boots, and connections for leaks, including the plenum and the spots where ductwork passes through walls. Our technicians have up to 13 years of experience reading these systems.
- 3
Repair and reseal. We repair torn flex, damaged metal, and loose connections, then seal the joints with mastic where it’s accessible. Failed insulation on unconditioned runs gets replaced.
- 4
Containment and cleanup. We use Nikro negative-air equipment during service to keep dust and debris contained. The work area is left clean, and we don’t consider a job finished until it is.
- 5
Verification and recommendations. We recheck airflow and show you before-and-after photos of the ductwork. If the system would benefit from a Honeywell or Aprilaire filtration upgrade, we’ll recommend it, and if it needs a full cleaning first, we’ll say so.
See the difference
Before
After
Before
After
Before
AfterHow Much Does Duct Repair & Sealing Cost in Williamsburg?
Duct repair and sealing in Williamsburg typically runs from about $250 to $1,200 for a residential system, depending on how much ductwork is accessible and how many leaks and damaged runs we find. A focused repair on one or two runs tends to land at the low end. A whole-system reseal with insulation replacement on unconditioned runs sits at the high end.

| Service | Typical Range |
|---|---|
| Targeted air leak repair | $250 – $450 |
| Flex duct repair or reconnection | $300 – $600 |
| Mastic sealing of accessible joints | $400 – $800 |
| Duct insulation replacement | $350 – $900 |
| Full system reseal with repairs | $700 – $1,200 |
What affects the price: how much of the ductwork is behind walls or in tight chases, how many runs need repair, and whether insulation has to be replaced. To avoid overpaying, ask for a written estimate that lists each repair, not a lump sum. Our estimate is free, and it sets the final price before any work starts.
Duct Repair & Sealing Near Williamsburg – Our Service Area
We serve Williamsburg and the surrounding Brooklyn neighborhoods, including Bedford-Stuyvesant, Clinton Hill, Prospect Heights, Fort Greene, Crown Heights, Bushwick, Park Slope, Brooklyn Heights, Brownsville, East Flatbush, and Flatbush. We also handle duct repair & sealing in Bedford-Stuyvesant and duct repair & sealing in Clinton Hill for homeowners and property managers who want the system sealed, not just vacuumed. Fast dispatch from 7am to 7pm, Sunday through Friday. Call to book an inspection.
Serving Williamsburg, NY – Our Local Coverage Area
We serve Williamsburg and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked Questions – Duct Repair & Sealing in Williamsburg
Duct repair and sealing is the process of fixing damaged ductwork and closing leaks at joints, seams, and connections so the system stops losing air. It’s different from cleaning, which removes debris, because sealing addresses the gaps that let dust and conditioned air escape. We repair the damaged runs and apply mastic where it will hold, then verify airflow. Call (833) 508-9915 for an inspection.
Most residential jobs take two to four hours depending on how many runs are accessible and how many leaks we find. A single flex repair can be quick. A whole-system reseal with insulation replacement takes longer, and we’ll give you a realistic window with the estimate. We don’t cut corners to speed up a job.
Most Williamsburg jobs run from about $250 to $1,200, depending on the number of leaks, how much ductwork is accessible, and whether insulation needs replacing. A targeted leak repair is at the low end; a full reseal with repairs is at the high end. Our estimate is free and the written estimate sets the final price. Call (833) 508-9915 for an exact quote.
Yes, we service Rotobrush and Nikro equipment and use both as part of our repair and sealing work. We also work with Honeywell and Aprilaire filtration products when the system would benefit from an air-quality upgrade. Whether you have those brands or any other make, we can help.
Same-day service is often available depending on the schedule and the scope of the repair. We answer 24/7 and fast dispatch runs from 7am to 7pm, Sunday through Friday. A call outside dispatch hours is booked into the next opening. Call (833) 508-9915 to check availability.
We stand behind our work, show before-and-after photos of the ductwork, and only close a job once airflow checks out. The written estimate spells out exactly what’s included so there are no surprises on the invoice. Any specific guarantee terms are confirmed in writing with your estimate.
Clear access to the registers, the attic or crawlspace, and the equipment area so the technician can reach the ductwork. Note which rooms feel off so we can check those runs first. If you have pets, secure them during service so doors can stay open. That’s usually all it takes.
Schedule Your Duct Repair & Sealing Service in Williamsburg Today
Leaky ductwork quietly drains your energy budget and leaves rooms uncomfortable year-round. One call covers the inspection, repair, sealing, and, if the system needs it, air duct cleaning in Williamsburg too. Call (833) 508-9915 for a free, no-obligation estimate. We answer 24/7.
Written by the team at Air Duct Cleaning Williamsburg.